How to change the pitch or tempo of a song
- Drop a song, a stem or a loop onto the changer, or press Choose a file. Mono and stereo files up to 12 minutes work.
- Set Tempo from 50% to 200%. Below 100% the song gets slower and longer; above it, faster and shorter. The pitch stays where it is.
- Set Pitch from 12 semitones down to 12 up, and Fine for cents. The length does not change. Below 75% tempo it goes up less far.
- To aim for a BPM, type the song's BPM or press Find BPM and key, then type the new BPM under it.
- Press Play to hear the change. Switch between Original and Changed to compare them at the same loudness.
- Press Make the WAV, then Download WAV.
The display is a control too. Pull the end of the lit wave along the ruler to set the tempo, or drag the wave up and down the semitone scale to set the pitch. Press either wave to play from that point.
The original file is never changed. If you only need the numbers first, the key and BPM finder reads a song's key and tempo, and the music production guides cover keys, tempo and arranging.
Tempo, BPM and length
Tempo is set as a percentage of the original speed. The new BPM is the old BPM times that percentage, and the new length is the old length divided by it: at 75% a 120 BPM song plays at 90 BPM and a three-minute song runs four minutes. To find the setting for a target, divide the BPM you want by the BPM the song has. The tool does that sum when you type both.
| From BPM | To BPM | Tempo setting | A 3:00 song runs |
|---|---|---|---|
| 120 | 90 | 75% | 4:00 |
| 128 | 124 | 96.9% | 3:06 |
| 100 | 110 | 110% | 2:44 |
| 140 | 150 | 107.1% | 2:48 |
| 174 | 87 | 50% | 6:00 |
| 90 | 120 | 133.3% | 2:15 |
The percentages are rounded to a tenth. Typing the new BPM into the tool sets the exact tempo.
A song that drifts in tempo keeps its drift: the tool scales time evenly and does not snap beats to a grid. The BPM by genre guide lists the usual tempo of each style if you are matching a song to a set or a session.
Changing the key of a song
A semitone is the distance from one piano key to the next, black keys included. Shifting a recording moves every note by the same number of semitones, so the song changes key and stays major or minor. Two semitones up takes C major to D major; three down takes it to A major. A cent is a hundredth of a semitone: use Fine to bring a recording that is slightly sharp or flat in line with an instrument.
| Semitones | Interval | Frequency ratio | C major, up | C major, down |
|---|---|---|---|---|
| 1 | Minor second | 1.059 | D♭ major | B major |
| 2 | Major second | 1.122 | D major | B♭ major |
| 3 | Minor third | 1.189 | E♭ major | A major |
| 4 | Major third | 1.260 | E major | A♭ major |
| 5 | Perfect fourth | 1.335 | F major | G major |
| 6 | Tritone | 1.414 | F♯ major | F♯ major |
| 7 | Perfect fifth | 1.498 | G major | F major |
| 8 | Minor sixth | 1.587 | A♭ major | E major |
| 9 | Major sixth | 1.682 | A major | E♭ major |
| 10 | Minor seventh | 1.782 | B♭ major | D major |
| 11 | Major seventh | 1.888 | B major | D♭ major |
| 12 | Octave | 2.000 | C major | C major |
Singers use this to move a backing track into their range, and producers to fit a sample or a loop to the key of a track. The guide to major and minor keys explains how keys relate, and the Camelot wheel shows which keys mix well.
To write a melody down as notes rather than move it, the audio to MIDI converter turns one sung or played line into a MIDI file.
How the tool works
Slow a record down and it drops in pitch, because speed and pitch are the same thing on a turntable. The dotted curve in the display marks that path. To leave it, the tool does two jobs. First it resamples the audio, which moves the pitch and the length together, with a filter so that nothing above the highest frequency the file can hold folds back down. Then it stretches or squeezes the result to the length the tempo asks for with a phase vocoder: it reads the audio in overlapping frames of 70 milliseconds, measures every frequency in each one and builds the sound again at the new length, keeping each frequency in step with its neighbours so that a drum hit is not repeated. That part is Signalsmith Stretch, an open source library that runs here as WebAssembly and loads only when you make a change. Both stereo channels are locked together, so the image holds.
That second job is where large changes show. Drums lose a little snap the further you go, and blur at the slowest, highest settings the tool allows. Below 75% tempo the pitch can go up less far, 5 semitones at 50%, because slower and higher than that, held notes start to warble. Voices keep no formant correction, so a big shift makes a singer sound smaller or larger as well as higher or lower. For the slowed, lower sound with a tail on it, use slowed and reverb, which keeps speed and pitch tied the way a record does.
What is in the download?
A 16-bit WAV at the sample rate the song was decoded at, mono or stereo as it came in, with TPDF dither. A quiet recording keeps its level. If the changed audio would peak above -1 dBFS it is turned down so its highest sample sits there, and playback in the tool uses the same gain. A loud, heavily limited master usually comes back several dB quieter for that reason: rebuilding the sound at a new length brings back peaks the limiter had flattened. Original and Changed are matched in loudness when you compare them, so the louder one does not win by being louder.
From the finished file you can go straight on: trim it in the audio trimmer or check its level in the loudness meter. The file moves between tools inside this browser and is not uploaded.
Questions
How do I change the pitch of a song without changing its speed?
Drop the song on the page, leave Tempo at 100% and set Pitch. Each step is one semitone, up to 12 either way, and Fine adds up to 50 cents. The song keeps its length and its tempo; every note moves by the same amount, so the whole recording changes key.
How do I change the tempo without changing the pitch?
Leave Pitch at 0 and set Tempo anywhere from 50% to 200%. Below 100% the song slows down and gets longer; above it, it speeds up and gets shorter. The key stays the same. To aim for a BPM, type the song's BPM (or press Find BPM and key), then type the new BPM under it.
Does changing the pitch or tempo change the length?
Only the tempo does. At 75% a three-minute song runs four minutes; at 150% it runs two. A pitch change on its own leaves the length exactly as it was, which is the difference between this tool and slowing a record down, where the two move together.
Will it hurt the sound quality?
A little, and more the further you go. The tool resamples the audio to move the pitch, then rebuilds it at the new length from overlapping 70-millisecond frames. A few semitones or a 10 to 20% tempo change usually sounds clean, with drum hits played once. Further out, drums lose a little snap, and at the slowest, highest settings it allows they blur. Below 75% tempo the pitch can go up less far, 5 semitones at 50%, because slower and higher than that, held notes start to warble. A big shift also changes the character of a voice, because the formants move with the pitch. Compare Original and Changed before you download.
What files can I use, and what do I get back?
WAV, AIFF, FLAC, MP3 and M4A, plus Ogg or Opus where your browser can decode them, in mono or stereo, up to 12 minutes. You get a 16-bit WAV at the song's own sample rate, with TPDF dither. The level is left alone unless the changed audio would peak above -1 dBFS, in which case it is turned down to that.
Is my song uploaded?
No. The file is decoded, changed and saved inside this browser tab. Nothing is sent anywhere, and you do not need an account.
How long can the file be?
Up to 12 minutes. The whole song is held in memory while it is changed, so the heaviest job (half speed and an octave down) fits about 11 minutes of 44.1 kHz stereo and about 5 minutes at 96 kHz. If a change will not fit, the tool says so before it starts.
Link to this tool
Showing someone how to change a song's key or tempo in a lesson, a forum answer or an article? Here is a plain link with a credit line, ready to paste. It is ordinary HTML: no embed and no script.
<a href="https://vitricaudio.com/tools/pitch-and-tempo-changer">Free pitch and tempo changer</a> by Vitric Audio